Electric Company Computer Drive User Manual

www.supportme.net
6-12 Configuration MN1942
6.4.3.1 Using the Commissioning Wizard
CAUTION: The motor will move during commissioning. For safety it is advisable to
disconnect any load from the motor during initial commissioning. The motor
can be tuned with the load connected after the Commissioning Wizard has
finished.
Each screen of the Commissioning Wizard requires you to enter information about the motor or
drive. Read each screen carefully and enter the required information.
On the Operating Mode screen, it is important to select ‘Host/Mint’ as the Reference Source.
This will allow the Autotune Wizard to operate correctly, and allow further initial testing to be
performed using Mint WorkBench. Although the MicroFlex e100 may eventually be controlled
over ETHERNET Powerlink (EPL), this reference source should only be selected after the
MicroFlex e100 has been commissioned and is ready to add to the EPL network. This can be
selected by choosing the Operating Mode tool in the Toolbox.
If you need extra help, click Help or press F1 to display the help file.
When you have completed a screen, click Next > to display the next screen. If you need to
change something on a previous screen, click the < Back button. The Commissioning Wizard
remembers information that you have entered so you will not need to re-enter everything if you
go back to previous screens.
During commissioning, changed parameters are stored in the MicroFlex e100’s temporary
(volatile) memory. For this reason, the Commissioning Wizard will occasionally prompt you to
save the parameters. Selecting Yes will cause the parameters to be saved in the
MicroFlex e100’s non-volatile flash memory, to be retained when power is removed. If you select
No, you must remember to use the Save Drive Parameters function before removing power from
the MicroFlex e100; this function is available on the Tools menu, or by clicking the
button on
the Mode toolbar . Saving parameters into flash memory will cause the MicroFlex e100 to be
reset.