Specifications

7
Space Vector Modulation Improves Efficiency
By controlling the IGBT power devices using Space Vector Modulation (SVM)
instead of the more usual carrier based pulse width modulation (PWM),
users can run servo motors at higher speeds without introducing harmonics.
In today’s world of increased productivity, this can translate directly into
greater machine throughput. SVM is supported by MicroFlex, MicroFlex e100,
EuroFlex and H2.
Digital Filters Eliminate Resonance
Advanced digital filtering techniques can be applied to reduce the effect of
mechanical resonance on system performance.
The drive has two separate digital filters. Each can be adapted to specific
frequencies as notch filters, or as low pass filters. Adapting the filters
to eliminate or reduce the effects of resonance allow higher system
gains and tighter control to be attained. This maximizes machine control
bandwidth, without suffering from the increased resonance and performance
degradation that would otherwise result.
Configuring these filters is aided by a simple filter design interface which,
combined with the Mint WorkBench oscilloscope and FFT (Fast Fourier
Transform) analysis, allows the user to test the axis open and closed loop
frequency response. The resonant components can then be identified and
filter designs tested for effectiveness.
Digital filters are supported by MicroFlex, MicroFlex e100, EuroFlex and H2.
 Fast Fourier Transform analysis
highlights resonant frequencies.
HMI Panel
Flex+Drive-II
Baldor Servo Motor
Baldor Servo Drive
NextMove Motion Controller
HMI Panel
Baldor
Induction
Motor
Baldor Inverter/Vector Drive
Baldor Servo Motor
Single Axis and Multi-Axis Solutions
Baldor's servo drives are ideally suited for both single
and multi-axis automation applications. interfacing
to Baldor's multi-axis controllers. Intelligent drives
(Flex+Drive-II, MintDrive-II) can operate as independent
machine controllers.
For operator interfaces, the Baldor HMI panels are
supported through RS232 or CANopen interfaces.
Alternatively, the supplied ActiveX controls can be used
to provide a PC front end.
Multi-axis applications are easily addressed with
Baldor's range of NextMove multi-axis motion controllers.
Available from 1 through to 16 axes of interpolated
control, the most demanding of applications can be accomplished.
Alternatively, MintDrive-II and Flex+Drive-II drives can be networked
together over the optional CANopen interface to provide a distributed
control system for loosely coupled multi-axis applications.
 Multi-axis product correction application,
using NextMove motion controller as machine
controller and Baldor servo drives
 Single axis indexer using MintDrive-II
as machine controller with Baldor HMI
operator interface.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com