Specifications

19
Industry Standard Interface
Using the industry standard ±10 V input command signal, EuroFlex
may be configured to operate in torque or velocity mode. A step
and direction input makes EuroFlex an ideal replacement for
stepper based applications that require higher speed or more
torque.
EuroFlex supports standard commutating encoder feedback for
the control of linear or rotary servo motors. An encoder output
channel allows the EuroFlex to interface to a motion controller,
such as Baldor’s NextMove range of Mint programmable motion
controllers or a PLC.
Simple Set-up
Mint WorkBench provides full auto-tuning capabilities and
diagnostics. Additional software features include advanced Low-
Pass and Notch frequency filters. These help in eliminating the
affects of resonant frequencies which can effect performance. This
in turn allows for stiffer control of the mechanical system, which
can ultimately improve throughput.
Different Gain Settings Handled with Ease
Up to 4 different gain settings can be stored in the drive. These
can be selected from two binary inputs on the backplane
connector. This allows easy swapping of drives, where different
gain terms may be used for different axes.
Optional Backplane
All connections are brought out via a DIN41612 Type M connector.
A backplane with pluggable screw terminated connectors and
D-type connectors is available as an option.
RS485/232 Programming Port
An RS485 port is available for communications, setup and
diagnostics. An optional RS232 port is also available.
Protection
DC bus over voltage monitoring; DC bus under voltage monitoring; Peak over current; Motor
short circuit; Over temperature; I2t over current
Regenerative Capability
Regeneration braking IGBT - requires external regen resistor
Control Supply Input
24VDC nominal (20-30VDC) @ 2A external (4A power on surge) - customer supplied
Connectors
DIN41612 Type M for all I/O connections for connection to backplane
Optional backplace available
Indicators
Three LED indicators for status and health
Dimensions
Standard EuroCard - 3U height
H: 100mm (3.9in) W: 55mm (2.2in) L: 160mm (6.3in)
Backplane dimensions: H: 100mm (3.9in) W: 130mm (5.1in)
Weight
0.47 Kg (1.0 lb.)
Operating Temperature
0˚C to 45˚C
Approvals
CE, UL, cUL
The optional backplane provides easy
connection to control signals. I/O
is brought out on to two part screw
terminals and encoder signals on to
D-type connectors.
Pre-made cables are available from
Baldor for connection to the motion
controller and drive and the drive and
motor.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com