User manual

Controlinc Digital Futronic VIII User Manual

Model DF320A Version 1.0

(

2003-01-31

)

6.3. Appendix B … AC Tech Drives (SCF Series)

Programming

VFC drives are programmed at EIM for use with the Futronic VIII system. However, some parameters

may need to be changed for tuning or in the event of drive replacement. The following table lists the

parameters affecting Futronic VIII operation. Refer to the AC Tech manual for instruction on editing

parameters.

Parameter # Description Setting # Value

05 Standard Speed Source 02 Preset Speed #1

10 TB-13A Function Select 05 Run Reverse

11 TB-13B Function Select 04 Preset Speed #2

17 Rotation 02 Forward and Reverse

19 Acceleration Time B ------ 0.1 seconds

20 Deceleration Time B ------ 0.1 seconds

43 Serial Address ------ 247

31 Speed #1 ------ 60 Hz(High Speed)

32 Speed #2 ------ 30 Hz(Low Speed)

12 TB-13C Function Select 09 Accel / Decel (A)

42 Accel / Decel (A) ------ 1 second

Although there are many parameters available for programming in the drive setting these parameters

will get the drive operating with the M2CP. Further tuning can be done with a PC and the AC Tech

Techlink software. Refer to the drive manual when making these adjustments.

Wiring

This model drive is usually mounted in the M2CP enclosure and wired by EIM. However, if the Drive is

remote mounted, connections should be made as indicated in Figure B1.

Figure B1