User manual

Controlinc Digital Futronic VIII User Manual

Model DF320A Version 1.0

(

2003-01-31

)

5. Storage Instructions

5.1. Short Term Storage

For storage at the job site for less than one year from shipment, follow these procedures. Actuator

should be stored in the recommended mounting position. The motor shaft should be in the horizontal

and Electrical Enclosure either horizontal or vertical. Actuator should be stored indoors free from job

site dirt, mud, moisture and temperature changes. If indoor storage is not possible, the actuator must

be stored off the ground, above possible water or snow level. If stored outdoors, remove M2CP and

store with other electrical and electronic equipment in protected warehouse. If M2CP is not removed,

Space Heater MUST be energized to protect Electrical and Electronic Controls. EIM supplies plugs in

each conduit entry. Do not remove these plugs until electrical hook-up. Cover units loosely with plastic

sheet. This serves as partial protection from rain.

5.2. Long Term Storage

For storage for more than one year from shipment, following these procedures. Store indoors or M2CP

must be removed and stored in protected area by following the same procedures for short term storage.

NOTE: FAILURE TO STORE ACTUATOR PROPERLY WILL VOID

WARRANTY OF ELECTRICAL & ELECTRONIC COMPONENTS.