User manual

Copyright © 2000 EIM Company, Inc 13840 Pike Road Missouri City, TX 77489 [phone] Page 10
Controlinc Digital Futronic VIII User Manual
Model DF320A Version 1.0
(
2003-01-31
)
If CCU software is not available all configuration parameters can be edited with the on board DIP
switches. Figure 3 indicates the location of the SW2 DIP Switch bank and the Setup Execute Button
used for editing the configuration. Setting the switches for the desired function and pressing the Setup
Execute Button will edit the parameter in the 320A configuration.
Figure 3
If the current configuration is not known begin by loading factory Defaults with the CCU software or by
setting the switches as shown below and pressing the Setup Execute Button.
After loading defaults set the motor starter type to VFC and the operating mode to precision positioner.
If CCU software is unavailable the DIP switch settings are shown below.
The 320A is will now function with the VFC drive and modulate from a setpoint sent over the digital
network. The digital network also provides feedback of the valve position.