Specification Sheet

ManualsBrandsBaldor-Reliance ManualsDefinite Purpose Electric MotorsMotor M1721T, 1.5/.67HP, 1740/1165RPM, 3PH, 60HZ, 182T, 352

Table of Contents

Table of Contents iMN408

Section 1

General Information 1−1...............................................................................

Overview 1−1.....................................................................................

Limited Warranty 1−1...............................................................................

Safety Notice 1−1..................................................................................

Receiving 1−2.....................................................................................

Handling 1−2......................................................................................

Storage 1−3.......................................................................................

Preparation for Storage 1−3.....................................................................

Removal From Storage 1−4.....................................................................

Equipment Marking for IEC Certified Product 1−5......................................................

Section 2

Installation & Operation 2−1...........................................................................

Overview 2−1.....................................................................................

Location 2−1......................................................................................

Mounting 2−1.....................................................................................

Frame Mounting Holes 2−2.....................................................................

Alignment 2−2.....................................................................................

Doweling & Bolting 2−3.............................................................................

Guarding 2−3.................................................................................

Power Connection 2−3.............................................................................

Grounding 2−

3................................................................................

Conduit Box 2−4..............................................................................

AC Power 2−4................................................................................

Rotation 2−4..................................................................................

Connection Diagrams 2−5......................................................................

Initial Lubrication 2−7...............................................................................

First Time Start Up 2−7.............................................................................

Coupled Start Up 2−8..............................................................................

Jogging and Repeated Starts 2−8....................................................................

Hazardous Locations 2−8...........................................................................

Selection 2−8.................................................................................

Protection Concepts 2−8.......................................................................

Repair of Motors used in Hazardous Locations 2−10....................................................

Section 3

Maintenance & Troubleshooting 3−1....................................................................

General Inspection 3−1.............................................................................

Relubrication & Bearings 3−1........................................................................

Type of Grease 3−1............................................................................

Relubrication Intervals 3−2......................................................................

Relubrication Procedure 3−4....................................................................

Shaker Duty Motors only 3−4...................................................................

Troubleshooting Chart 3−5

..........................................................................

Suggested bearing and winding RTD setting guidelines for Non−Hazardous Locations ONLY 3−6............