Instruction Manual

P/N 40694 Rev F April 27, 2010

Diagram 3

This unit is shipped with the wiring as shown. 110V or 240V can be applied to the black

and white wires. To match alignment of the white wire of the ozone generator connector

with the controller box connector, the white wire can be moved. Refer to Step 2 under

“FOR REPLACEMENT”.

Typical 110V/60Hz

240V/50Hz

Typical 240V/60Hz

Black White

Green

Black

Green

White

Balboa Water Group, Tustin, CA

Installation Instructions for Balboa’s

CD Cartridge Ozone Generator

CD Chip Ozone Generator

with Universal Input Power

zone

by Balboa is a reliable and ﬂexible system designed to generate ozone

for your pool or spa. It has Universal Auto-range Voltage that can operate with

any input voltage (110-240 VAC and 50/60 Hz).

Warning! Shock Hazard! No User Serviceable Parts. Do not attempt service of

this ozonator. Contact your dealer or service organization for assistance. Follow

all owners manual instructions. Installation must be performed by a licensed

electrician. Installation must be in compliance with all state, national, and local

building & electrical codes. No usable parts inside.

PAGE 1
Typical 240V/60Hz Typical 110V/60Hz or 240V/50Hz Black White This unit is shipped with the wiring as shown. 110V or 240V can be applied to the black and white wires. To match alignment of the white wire of the ozone generator connector with the controller box connector, the white wire can be moved. Refer to Step 2 under “FOR REPLACEMENT”.
PAGE 2
Power Cords Air Inlet (near power cord) CHP Diagram 2 Flow ter Diagram 1 Both diagrams, Diagrams 1 & 2, show that the ozone generators must be mounted with their inlets facing down. As shown (right), the chip generator outlet will be pointing to the left once installed. 4. Mate the AMP connector and power up the spa. Make sure that you are in filtration cycle and confirm that the light on the ozone generator window is on. 3. Insert the wire. You will feel it “click” into position when it is seated.