Installation manual

47
Configuring the System: Step 2 - Entering Configuration Mode
To Configure the System, move the SetUp-Run switch (S1) on the circuit board to the SetUp position.
The system will enter configuration mode. (The first wireless panel must be trained prior to use.
See previous page.)
Read page 45 regarding default configurations and
DIP switch settings. Verify that the DIP switch
settings reflect your equipment configuration.
If they are correct, move on to the next screen.
If the DIP switches do not reflect your
equipment configuration:
1. Correct the DIP switch settings, then
2. Move the SetUp-Run switch back to Run, then back
to SetUp again.
ENTERING CONFIGURATION MODE
0
Configuration D3 D2 D1
Pool Only Off Off Off
Spa Only On Off Off
Pool - Spa Combo Off On Off
Spillover On On On
Two Water Body Single Plumbed Off Off On
Two Water Body Dual Plumbed On Off On
Expansion Boxes
Verify S2 dip switches on the
PoolControl and press ‘Select’
button on the Panel.
Verified Setup?
No
Yes
Config Mode, Wait..
Entered
!
Panel display will indicate
that the system is entering
configuration mode.
Verify DIP switch settings match
your equipment.
1
2
3
Yes
No
Exit from Configuration
Change S1 to RUN position on
the PoolControl and press
‘select’ button on the Panel
You may be reminded to reset
the S1 switch on the Pool Control
to continue.
When the S1 switch is moved from Run to Setup, the
following occurs;
a. The relay resets in the Service Box.
b. The service Panel will read SETUP MODE.
c. The handheld wireless panel will go into Configuration
Mode and will momentarily show menu 1 (below) as it
initializes for configuration.
Fig. 33 “S1” Switch and DIP Switches
Refer to Fig. 13
SYSTEM CONFIGURATION