Datasheet

LOCATION OF CONTROL
1. + Button
2. / SET Button
3. - Button
4. ºC / ºF B u tt on
5. RESET Button
6.
ON / OFF S w i t ch
7. MODE (Photo Sensor but t on)
BATTERY INSTALLATION
• Open the battery door.
• I nsert new f our (4) “AA” batteries in polarity ( +
) and ( - ) as indicated.
• Close the battery door.
GETTING STARTED
1. When power up, it initializes at 2012 Jan 1, 00:00.
2. Slide to the
ON / OFF switch to “ ON ” .
3. Press the
/ SET button.
4. In a normal condition, the clock can complete receiving signal and time adjustment in 10 to 15 minut es.
5. In case you find the clock cannot set itself, then press & hold / SET button for manual set. (Please refer to
manual clock set instruction at the next page.)
As long as batteries are supplying power to the unit, it receives the time signal and adjust time automatically. No manual
adjustment is required after power up. A ccurat e adjustment of the clock based on the time signal is supported in the
c ontinental.
You are recommended to leave the clock overnight for searching time signal since night time allows better transmission of time signal.
SIGNAL RECEIVE OPERATION
The unit automatically receive the time signal everyday at midnight and make any r equir ed adjustment to the time s et t ing.
The WAVE OK indicator and the antenna tower icon appear on the display if the time signal is successfully received or after manual
pr ess ed / SET button.
Important : Do not perform any button or switch operation while a signal receive operation is in progress.
TRIGGERING A RECEIVE OPERATION MANUALLY
You can trigger a signal receive operation at any time by pressing the
/ SET button, which cause the unit to perform an immediate
signal receive operation.
UNSUCCESSFUL SIGNAL RECEPTION
If the automatic update is unsuccessful, the wave on top of the antenna tower and t he WAVE OK icon will be disappeared, and the
unit will
re-try to receive the signal again every hour.
If unsuccessful signal reception after battery installation or after reset, the unit will keep trying until time signal reception successful.
UNABLE TO RECEIVE WAVE SIGNAL
If you are not able to receive the wave signal please slide
ON / OFF switch to “ OFF” position.
MANUAL SET THE CLOCK
To manual the clock, you should press and hold the
/ SET button for 2 seconds to enter
the setting mode :
1st STEP: To Set the Time Zone & Daylight Saving Time ( DST )
1. Press and hold the
/ SET button for 2 seconds to enter the
Time Zone and DST setting mode.
2. Press + button to choose your desired Time Zone.
3. Press - button to toggle between Daylight Saving Time ( DST )
ON or OFF mode.
Time Zone and DST