Installation Manual

BAK Industries • 5400 S. State Road, Ann Arbor, MI 48108 • 844-779-8986 • bakindustries.com

Part# 318B0017 Rev. 9-15-17

Roll the cover open and place

the D shaped bumpers to the

aluminum underside where

they will prevent contact if

the cover is rolled all the way

open. The straps will hold the

cover off the cab and glass

when secured.

Mount the strap clamp assembly as far forward on the

rail as possible and tighten. Repeat on opposite side.

If the side seals of the cover

appear

wrinkled you may leave the truck in the

sun to assist the seals to lay ﬂat. To

expedite, apply heat with a hair dryer or

heat gun. See this video for a good look

at how it’s done.

Check to see

that the latches

at the tailgate

fully engage

and make

proper contact

with side rails.

https://www.youtube.com/watch?v=H___Dl2vJjg

IMPORTANT