Installation Manual

Slide two of the accessory bracket mounts into
each rail. Align with the rail interior prole
as shown.
Truck Hero Inc. 5400 S. State Road Ann Arbor, MI 48108 734 677-0444, Fax: [phone]
Visit us at truck-hero.com
Slide one accessory bracket mount to the front, leaving
the other at the tailgate end of the rail.
(Notch is at the
tailgate end)
With the accessory bracket mounts slid into the rails, assemble the brackets as shown. Loosely tighten the screws.
Accessory Rail Left
Accessory Rail front, copied on left and right
Tap Plate
Tap Plate
Accessory Bracket Mount
Accessory
Bracket
Mount
Screws
Screws
Cab Bracket Mount
(notice the slotted holes are on the top)
Tail Bracket
Mount Left
Tail Bracket
Mount Right
Accessory Rail Right
Tap Plate
With the brackets mounted to the rails, place the rails on the truck. Position the rail so the front
cap pad rmly contacts the bulkhead. Align the brackets so that they line up with the
factory tie-down hook bolt holes, then thread in the factory bolts and tighten.
Tighten the front hardware while pushing down on the rail to make good seal contact
with the truck bed at the same time also pushing the rail forward to keep good
contact between the cap pad and bulkhead.
Continue to push down on the rail while tightening
the rear bracket hardware.
Cap pad
to bulkhead
Tighten both Torx bolts,
then tighten both
Allen head bolts.
Tighten both Torx bolts,
then tighten both Allen
head bolts.
A
B
Push down
Push down
1
1
2
2