Installation Manual

SUPPLEMENTALINSTALLSHEET
ToyotaTacoma2016+
Part# 318A0050 Rev. 12-18-15
bakindustries.com
5
5
Position the rail with the silver, slotted
bracket all the forward, towards the cab,
the front of the vehicle.
A
Align the rail with the
front/cab bulkhead,
per Step 5A,
tighten the screws.
Remove the end cap from the factory accessory
track system.Then slide the buckle strap bracket
into the rail. Replace the end cap.
6
7
Return to standard Installation Sheet, Step 8.
Forward, cab end
Mount the strap clamp
as far forward on the rail
as possible and tighten.
Repeat on opposite side.
Mount the supplied Revolver rail into
the original factory mounting holes
using the supplied long Torx screws
through the middle slot of the ‘S’ clamps.
Remount the factory
track system using the
supplied short Torx screws
into the threaded holes
at the bottom of the
‘S’ clamps.