Installation Manual

IMPORTANT: READ FIRST
Install of Revolver X2 Rail to Ram Box Accessory Rail
RAM BOX SUPPLEMENTAL INSTALL SHEET
Steps 2 through 6 are required
and repeated on both sides.
2
Remove the factory accessory
rail end cap, and any
accessory cleats.
Guide the tonneau rail into the
upper half of the factory
accessory rail
The tonneau rail profile
is designed to tightly fit
the profile of the factory
accessory rail.
3
Use a soap and water mix
to help with sliding the
rail and the rail seal
all the way along the factory
rail slot to the front of the bed.
1
Install the 3/4” bulkhead seal to the top of the bulkhead
at the edge of the bed opening.
Part# 318A0064 Rev. 3.1.16
HRC