Installation Manual

Warranty
BAK® Industries (“BAK”) warrants your Revolver X2 Hard Rolling Cover to be structurally free from defects in materi-
al and workmanship for a period of 3 years from the retail date of purchase. Warranty registration must be on file and/
or proof of original purchase (detailed and dated receipt) required for warranty service. Warranty is nontransferable and
applies to the original purchaser of the BAK product only.
BAK reserves the right to determine whether a product needs to be repaired or replaced. No labor or service allowance
is given or implied. The warranty will be void if the product has been damaged by accident, unreasonable use, neglect,
improper service/installation/removal, modifications, acts of God or normal wear and tear or other causes not arising out
of defective materials or workmanship. BAK assumes no liability for injury, loss, incidental or consequential damages.
BAK reserves the right to substitute an entire replacement system or provide other remedies than those listed in this
warranty for discontinued products or other reasons. Shipping charges will apply for any repair or replacement.
Improper cleaning may also void your warranty. It is recommended to use the approved BAK treatment of the vinyl as
outlined below or clean with soap and water only. Do not use vinyl conditioners (i.e. Armor All®) because they will shrink
the vinyl.
BAK is committed to providing you with our best service at all times. Please feel free to contact us should you require any
assistance with your BAK product.
CARE AND MAINTENANCE
Revolver X2 tonneaus are made from durable materials and require simple care to ensure a long life of performing well
and looking great.
Cleaning the Top (Washing)
These stylish covers incorporate OE marine grade vinyl laminated on the top surfaces. Standard automotive soap and
water used with a soft sponge or cloth is recommended for cleaning. Shammy dry to prevent water spots and ensure a
rich dark finish.
Treating the Vinyl Top
3M™ 303® Aerospace Protectant may be used to keep the vinyl surface clean and protected from the elements and will
also remove any water spots that may have developed. 303 Aerospace not only protects against fading, discoloration
and cracking from harmful UV rays, but repels dust and stains. Simply spray on and wipe dry for a beautiful, matte finish
thatprotects your cover from road grime and dust. Do not use vinyl conditioners (i.e. Armor All®) because they will
shrink the vinyl.
Maintenance
It is recommended that you periodically check that the cover is securely attached to your truck bed. Inspect the clamps
and front mounting bolts to ensure they were properly installed and have not come loose or knocked out of adjustment
during operation. Covers that are used with high frequency or that are subject to the vibrations and impact from rough
roadways can cause the cover to require adjustment.
Lubricating the Latches
It is recommended that you periodically inspect and service the latches on the end of the roll top. Clean away any excess
dirt or grime and use a spray lubricate. Ensure the latches move freely in and out to properly engage the side rail and
provide proper performance with optimum security. Be careful not to overspray the cover. Wipe away any excess around
the latch location.
BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 818-365-9000 • Fax: [phone] • bakindustries.com
Part# P39INSTALL Rev. 4-24-15
REGIS TER YOUR
WARRANTY NOW AT
BAKINDUSTRIES.COM