Installation Manual

”Click”
”Click”
FINAL ADJUSTMENT
BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 818-365-9000 • Fax: [phone] • bakindustries.com
Part# P39INSTALL Rev. 4-24-15
Remove any snow or foreign
matter before rolling cover.
Do NOT tow your vehicle from the
rear with this cover on your truck.
IMPORTANT Safe operation and use
IMPORTANT NOTICE
While driving, cover must be completely at and secure with BOTH rear latches engaged and
in the closed position OR completely rolled up and secured at the cab with the provided straps.
DO NOT DRIVE with cover partially opened.
Tonneau Cover Positions While Operating Vehicle
Prior to vehicle operation, tonneau cover MUST be properly secured.
CLOSED POSITION (FIG 1)
Cover must be closed and FULLY LATCHED ON BOTH SIDES of the tonneau
side rails.
OPEN POSITION (FIG 2)
To drive with your Revolver X2 in the open position, simply make use of the provided
tie down straps. Roll the cover forward and stop approximately 4” from the cab and
insert the strap clips into the buckles at the end of the cover. Ensure BOTH
strap clips are fully inserted and tighten the straps with the adjustment locks
to ensure the cover doesn’t roll or shift during vehicle operation.
Cover Operation
TO CLOSE THE COVER (FIG 3)
Roll the top towards the tailgate and rotate the tail rail downwards towards the
rotating locking levers.
WARNING – When closing the cover ensure rear latches on BOTH sides are fully
engaged underneath the rails before operating the vehicle.
TO OPEN THE COVER (FIG 4)
Pull downwards on latch release cable located on either side of the cover and rotate
tail rail forward and into a rolling motion. Cover should be rolled into a bundle towards
the cab of the vehicle and only driven with the cover secured with the provided straps.
DO NOT ATTEMPT TO DRIVE WITH THE COVER IN THE
PARTIALLY OPEN POSITION!
ADDITIONAL IMPORTANT OPERATING TIPS
z Tonneau cover MUST be free of foreign material including snow and ice
before opening rail top.
z Do NOT tow your vehicle from the rear with the tonneau on your truck.
z Do NOT operate vehicle with objects on top of cover.
FAILURE TO FOLLOW THESE CAUTIONS MAY RESULT IN
SEVERE DAMAGE AND WILL VOID YOUR WARRANTY!
FIG 2: OPEN POSITION
FIG 1: CLOSED POSITION
FIG 3: TO CLOSE THE COVER
FIG 4: TO OPEN THE COVER