Installation Manual

BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 818-365-9000 • Fax: [phone] • bakindustries.com
Part# P39INSTALL Rev. 4-24-15
17
18
19
Roll the cover open and place
the D shaped bumpers to the
aluminum underside where
they will prevent contact if
the cover is rolled all the way
open. The straps will hold the
cover off the cab and glass
when secured.
16
Mount the strap clamp assembly as far forward on the
rail as possible and tighten. Repeat on opposite side.
If the side seals of the Revolver X2 cover
appear wrinkled you may leave the truck
in the sun to assist the seals to lay flat. To
expedite, apply heat with a hair dryer or
heat gun. See this video for a good look
at how it’s done.
Check to see
that the latches
at the tailgate
fully engage
and make
proper contact
with side rails.
https://www.youtube.com/watch?v=H___Dl2vJjg
IMPORTANT