Installation Manual

Verify approximately
1/8” gap remains on
both sides of the cover
and it rolls freely in the
opening. Correct spac-
ing ensures the locking
rail secures the roll top.
Install mounting
hardware loosely
underneath the
slotted bracket on
the rail. Start with
the rubber wash-
er, then the large
flat washer, then
finally add the
nylon lock nuts.
Leave the nuts
loose for now.
BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 818-365-9000 • Fax: [phone] • bakindustries.com
Part# P39INSTALL Rev. 4-24-15
10
11
12
15
As you fold the roll top flat the buckle will rest just beyond
the front edge of the cover.
When correctly installed, the vinyl edges of roll top
align squarely with the rails in the 4 corners. The latch
assembly will align with the silver locking levers at the
tailgate on each side.
13
It is necessary to check the roll top fits correctly between
the rails. Roll the cover from front to back and back to
front to verify it rolls freely on the rails.
14
Slam latch MUST hit
locking lever squarely
Once properly aligned, roll the cover open ensuring you
DO NOT misalign the roll top. Tighten the nylon lock nuts
at the front. Recheck the roll top operates correctly. When
latched check the locking rails prevent the cover from
lifting on both sides.
Align the front vinyl edge of the cover with the front
edge of the Revolver X2 rail (not the rubber seal).
VINYL
RAIL