Installation Manual

10 ft/lbs
BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 818-365-9000 • Fax: [phone] • bakindustries.com
Part# P39INSTALL Rev. 4-24-15
6
Place the rear clamp as close to the tailgate as pos-
sible, should be less than 12”. Check all clamps are
square and tight with approx 10 ft/lbs of torque. Cau-
tion: over tightening the clamp may warp the bed cap.
5
Apply downward
pressure to the rail
when tightening the
clamp to ensure the
rail sets flush and seals
properly. A second set
of hands may help.
8
7
Place the 2nd clamp near the center of the rail. See
steps 4 and 5 to ensure the clamp goes on correctly.
(8’ beds-evenly space 2 clamps between ends).
With both rails clamped in place, rest the roll top on the
rails at the tailgate, roll forward into the opening and remove
and discard all packaging materials.
9
At the front cab, fold the cover back and insert 2
mounting bolts through the keyed slots. Repeat on
opposite side.