Installation Manual

15
16
Assemble the washers
from underneath and
loosely tighten the knob.
Do not over tighten.
17
Unfold the cover towards the tailgate. Make sure the cover
fits squarely between the rails.
The covers aluminum frame should fit just inside
the tailgate when the adjustment is made correctly
(approx. 1/4” clearance).
18
The flap seal will rest
on top of the tailgate.
19
The large flat bolt goes down through the
front panel on each side. Underneath the
cover, the order of washers is as follows:
rubber washer first, then large flat stainless
washer, then the lock washer, and finally the
5 star finger knob as shown to the left.
14
20
Once
positioned,
fold cover over
toward cab
and tighten
the knobs
until the lock
washer flattens
out and locks
the knob
securely to
the bracket.
Route the front drain
hoses from the end
of the BAKFlip rail
out through manu-
facturer available bed
plug. Simply remove
these plugs or drill a
7/8” hole through the
plastic. If you have a
drop in plastic bed-
liner, simply run the
drain tubes behind
or under the liner.
BAK Industries • 1100 N. Glenstone Ave. Suite 140, Springfield, MO 65802 • 844-779-8986 • bakindustries.com
Part# 318A0029 Rev. A