Owners manual

10 ft/lbs
Insert the large flat bolt with the supplied rubber
washer through the front panel and silver slotted
bracket underneath. Repeat on other side.
BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 818-365-9000 • Fax: [phone] • bakindustries.com
Part# 318A0029 Rev. 2-5-16
6
Place the rear clamp approx 6 inches from tailgate. Tighten
all the clamps until snug. Then torque an additional 1/2 turn
(approx 10 ft/lbs). Repeat steps 2-7 on opposite side.
5
Apply downward
pressure to the
BAKFlip rail when
tightening the clamp
to ensure the rail
sets flush and seals
properly. A second
set of hands
may help.
9
11
Set the cover in the folded position on the BakFlip rails
towards the front of cab.
10
The small panel faces
forward, toward the cab
and folds down over
the silver brackets. The
front panel must sit just
inside the bulkhead rail
with the seal resting on
top of the rail. Fold the
panel down and align it
so it is setting squarely
on the rails and align
the mounting holes
with the silver slotted
brackets on the rails.
The large flat bolt goes down through the
front panel on each side. Underneath the
cover, the order of washers is as follows:
rubber washer first, then large flat stainless
washer, then the lock washer, and finally the
5 star finger knob as shown to the left.
12
7
Place the 2nd
clamp near the
center of the
rail. See steps 4
and 5 to ensure
the clamp goes
on correctly.
(8’ beds-evenly
space 2 clamps
between ends).
8
Before mounting the cover on truck, using a screw-
driver install the two buckle ends into pre-drilled
holes on the front header with the provided machine
screws and threaded posts. DO NOT use a screw
gun, securely tighten by hand only.
IMPORTANT