Owner`s manual

How to Ride your Bike

Proper running-in is important for the better life and

trouble free performance of the vehicle.

• During first 2000 kms running-in period do not

exceed following speed limits.

Kms 1st 2nd 3rd 4th 5th

0 - 1000 14 22 31 38 45

1000 - 2000 19 31 43 52 62

• Always keep the speed below the limits mentioned

in the table.

• Do not race the engine excessively.

• Do not start moving or race the engine immediately

after starting. Run the engine for a minute at idle

speed to give the oil a chance to workup into the

engine.

Running IN

Riding the Bike

Before starting the vehicle and with the ignition key off,

adhere to the following first thing in the morning or after

a long period of non-use (whichever is the case).

Depress the clutch lever completely. Kick the kick lever

all the way down to its stop, briskly a couple of times.

Release the clutch lever.

Starting the Engine :

• Keep the fuel tap to ON or RES position.

• Turn ignition switch to ON position.

• Turn Kill switch to ( ) ON position.

• Confirm that the vehicle (transmission) is in neutral.

• Keep the throttle completely closed, push the starter

button ( ) or kick the engine with kick starter lever.

CAUTION : Do not operate the starter continuously

for more than 5 sec. Wait for 15 sec. before you re-

start.

NOTE : The motorcycle is equipped with a starter

lockout switch. The vehicle can start in any gear when

clutch lever is depressed.

It is recommended to start the engine with the

transmission in neutral.

Moving Off :

• Check that Center/Side stand is up.

• Depress the clutch lever.

• Shift into 1 gear.

• Open the throttle and release the clutch lever slowly

and simultaneously.

• As the clutch starts to engage, open the throttle a

little more, giving the engine just enough rpm to

keep it from stalling.