Operating instructions, manufacture statement of origin, owners manual and tools are located in box under seat 1.
"X[ 2. Removeboltsasindicatedin l diagram from both sides of metal frame 3. Carefully lift metal frame. 5. Remove rear tie down 4.
i6. Remove front grill cover i 7. Remove parts box located under seat 1 / / / / / /' /' / // _9.
! - !
/ /1 1 4.Bendendsofcotterpinaspict.red, l WARMNG: FAILURE TO _NSTALL COTTER P_NS ON AXLES CAN RESULT IN INJURY OR DEATH.
Eye Protection Rubber Gloves The following procedure is very dangerous and should be performed with the utmost care and attention. Wear protective eyewear, rubber gloves, and have water available shoumdemectromyte come in contact with skin or eyes. KEEP ALL CHLLDRENAWAY FROM THEAREAVVH_LETH_SPROCEDURE NSBEING PERFORMED. POmSON- CAUSES SEVERE BURNS Contains suffuric acid. Avoid contact with skin, eyes, or cmothing To prevent accidents, rinse empty container with water.
_g the batter_: Place battery on level surface. Remove Vent cap from battery vent located on top side portion of battery. (see figure 20) Remove ceil caps using a pair of pliers. (see figure 21) Wear eye protection and rubber gloves for this step. Cut off tip of electrolyte bottle and attach tube. Place other end of tube in battery and allow the electrolyte to drain in battery ceil. Fill battery to upper level mark located on front of battery.
3. Turn power switch to "RUN" as specified in owners manual. CAUTION Fill engine with correct amount of oil and fuel tank with fuel as specified inthe owners manual Refer to owners manual for proper starting insructions. The engine oil shoutd be drained and replaced with new oil before starting the fist time.
