Installation guide

Note:The following page is for vehicleswith battery's containingseparateelectrolytepack.Most
batteries will comewith the electrolytealready sealed intothe battery.
_g the battery:
Placebattery on levelsurface.Remove sealingtape from top.
(seefigure 20)
Takethe electrolytecontainerout ofthe plasticbag.
Place electrolyte container upside down with the sealed silver
mouths of the electrolyte bottles in line with the six filler
holes of the battery. (see figure 21)
Push the container down strongly enough to break the silver
seals.
As electrolyte starts flowing into battery,air bubbles will
come up from the mouths of the plastic electrolyte bottles.
Leave bottles upside down in battery holes until electrolyte is
completely drained.
Never leave children unattended around battery.
If air bubbles cease to float to the top of the electrolyte
bottles, tap lightly on top.
DO NOTremove container from batterywhile it is draining.
Never cut or pierce electrolyte container.
After all the electrolyte has drained from the bottles into
the battery, pullplastic electrolyte bottles gently out of the
battery.
Discard empty electrolyte bottles in a waste area that is
inaccessibleto children and animals.
After filling, let battery stand for at least 30 minutes before
charging. This allows the electrolyte to penetrate plates for
optimum performance and ensures longer battery life.
After 30 minutes the battery is ready for its initialcharge.
Place cap strip loosely over the filling holes as shown in the
picture. (seefigure 23)
Figure 20
Figure 21
Figure 23
9