Installation guide

Howto InitiallyCharge the battery_:

1. Connect the red positive(+) cable to the red positive(+)

pole of the battery.

(see figure 24)

2. Connect the black negative (-) cable to the black negative

(-) pole of the battery. (seefigure 25)

Note: The red positive (+) cable has a larger diameter

than the black negative y cable.

Charging rate: Charge battery @0.7Amps for

5 ~ 10 hours.

• After charging iscomplete, pressdown firmly with

both hands to seat the caps, (Do not pound or

hammer). The battery is now sealed. (seefigure 26 )

• install battery intobattery compartment. The battery

terminals should be facing the front (see figure 27)

• Once battery isfirmly seated in battery compartment

attach the red positive wire to the red positive terminal

on the battery.(seefigure 28)

• Then attach the black negative wire to the black

negative terminal on the battery.

(see figure 28)

• install the battery bracket (see figure 28)

Figure 24

Figure 25

Figure 26

NEVERREMOVETHE STRIPOF CAPS

NORADDANY WATEROR ELECTROLYTE.

Battery bracket

Red

Figure 27

Black -

Figure 28