Service manual

Bair Hugger Model 775 Temperature Management Unit Service Manual

Check the 3M

Bair Hugger

therapy website to ensure you have the most recent version of this document. www.bairhugger.com reorder #202526A

Replacing the Hose

Service frequency

As needed�

Tools/equipment

• Replacement hose

• Needle-nose pliers

• Strap wrench (optional)

Method

Detaching Hose

1� Disconnect the temperature management unit from the power source before replacing hose�

2� Unscrew the hose collar�

3� Slide the hose out of the temperature management unit� e hose will still be attached to the unit by

a cable�

4� By hand or using a needle-nose pliers, carefully detach the cable connector from the header plug

located inside the hose connector (see "Figure 3� Hose replacement")�

Figure 3. Hose replacement

Reattaching Hose

1� Attach the cable connector of the new hose to the header plug, making sure that the protrusions on

the connector align with the corresponding slots on the header�

2� Align the at section of the hose end with the corresponding at part of the unit’s hose connector and

slide the replacement hose into the temperature management unit�

3� Firmly screw the hose collar back into place�

4� Reconnect the temperature management unit to a grounded power source�

5� Calibrate operating temperature settings� See page 12�

6� Perform over-temperature detection system test� See page 14�