Service manual

English 202430A
5
Check the 3M
TM
Bair Hugger
TM
therapy website to ensure you have the most recent version of this document. www.bairhugger.com reorder #202430A
minutes or according to institutional protocol. Monitor
the patient’s vital signs regularly. Adjust air temperature or
discontinue therapy when the therapeutic goal is reached or
if vital sign instability occurs. Notify physician of vital sign
instability immediately.
3. Do not leave pediatric patients unattended during therapy.
4. Do not initiate temperature management therapy unless
the temperature management unit is free from mechanical
damage and is safely placed on a hard surface or securely
mounted. Otherwise, injury may result.
5. To prevent tipping, clamp the Model 775 temperature
management unit to an IV pole at a height that provides
stability. We recommend clamping the unit no higher than
44” (112 cm) on an IV pole with a minimum 28” (71 cm)
diameter wheelbase. Failure to do so may result in IV pole
tipping, catheter site trauma, and patient injury.
6. Electrical shock hazard. Do not disassemble the temperature
management unit unless you are a qualified service
technician. There are electrically live parts within the unit
when it is connected to a power source, even when the unit
is in Standby mode.
7. To reduce the risks associated with environmental
contamination follow applicable regulations when disposing
of this device or any of its electronic components.
NOTICES
1. The Bair Hugger temperature management unit meets
medical electronic interference requirements. If radio
frequency interference with other equipment should occur,
connect the unit to a different power source.
2. Federal law (USA) restricts this device to sale by or on the
order of a licensed healthcare professional.
3. To avoid Bair Hugger warming unit damage:
• do not immerse the Bair Hugger warming unit or
warming unit parts or accessories in any liquid or
subject them to any sterilization process.
• do not use solvents such as acetone or thinner to clean
the warming unit; avoid abrasive cleaners.
• clean warming unit exterior with soft cloth using plain
water or a mild, all-purpose or nonabrasive cleaner.