User's Manual
Wiring Diagram - For Optional Start Assist- Boost upto 80A Output :
For BLUE, ORANGE and GREEN Wires refer to previous wiring diagram
NOTE: 100A or greater rated cabling must be used between
solenoid and batteries.
Optional Start Assist and Boost Charge:
The optional Solenoid Kit (Part No. BTDC40KIT
provide the features of the unique Start Assist and Boost Charge modes.
Start Assist:
With the solenoid connected it enables the BTDC40 to automatically provide assistance from the Auxiliary
Battery on starting of the vehicle. Provided the Auxiliary Battery is charged.
Following a failed cranking attempt due to low main battery charge- Release the key so it returns to
“ON” position, do not bring it to the “OFF” or “ACC” position. Now within a couple of seconds try cranking
Boost Charge:
With the addition of the solenoid boost charge will allow up to 80A
charging conditions. This initial Boost Charge Mode reverts automatically to normal charging once the
auxiliary recovers from deep discharge.
100A> Rated
Cable
Signal
Wire
100A> Rated
Cable
Kit Sold Separately)
All products manufactured or supplied by BAINTECH to a person dened as a “Consumer” come with guarantees that cannot be
excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for
any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure. For full warranty terms visit -
https://www.baintech.com.au/contact-us/warranty-2