User's Manual

ManualsBrandsBaintech ManualsCaravan & RV12V 150Ah Standard Power Compact Lithium Battery with 40A DC-DC Battery Charger

Features Include:

• 3-Stage 12V Booster Battery Charger

• Output Current : 80A Max with optional kit. 40A Max standard wiring.

• Selectable output voltages for Lithium, Sealed Lead Acid or Vented Lead Acid

• Over Current and Temperature protections for extra product reliability.

• Precise under voltage protection : No need for external isolator.

• Remote LED indication for battery charge status.

• Very low standby current: <3mA

• Optional Start Assist and Boost Charge features.

Next Generation DC to DC

Booster Battery Charger

12VDC to 12VDC 40A

Operating Instructions

Please read these instructions before use

The BTDC40 is able to utilize up to 80A charging to the auxiliary battery using our new

boost mode (Kit Sold Separately) and 40A when wired with a standard configuration.

This is all still acheived in the same extremely compact package (373cm³) while still

boasting all the features of a booster battery charger in a weather, dust and vibration

resistant package.

TECHNICAL SPECS - BTDBM

Input voltage 5v to 17v

Current draw 35mA running - 0.4mA standby

Accuracy 50mV

Dimensions L X W X H 59mm x 44mm x 21mm

Connections 1.5M 4-Core Cable

Summary of content (4 pages)

PAGE 1
Next Generation DC to DC Booster Battery Charger 12VDC to 12VDC 40A Operating Instructions Please read these instructions before use The BTDC40 is able to utilize up to 80A charging to the auxiliary battery using our new boost mode (Kit Sold Separately) and 40A when wired with a standard configuration. This is all still acheived in the same extremely compact package (373cm³) while still boasting all the features of a booster battery charger in a weather, dust and vibration resistant package.
PAGE 2
Next Generation DC to DC Booster Battery Charger 12VDC to 12VDC 40A Operating Instructions Please read these instructions before use Operational Parameters Maximum Charge Current (with Boost Kit) 80 Amps Maximum Charge Current (Standard Wiring) 40 Amps Input Operating Voltage Range 11VDC to 16VDC Maximum Charge Voltage for Flooded Cell 14.5V Maximum Charge Voltage for Lithium 14.8V Maximum Charge Voltage for AGM/GEL 14.3V Float Voltage 13.5V Lithium Maintenance Charge 13.
PAGE 3
Wiring Diagram : Standard installation - No Start Assist. Max 40A Output Chemistry Selection To Ignition Switch of vehicle LED ORANGE BLUE BROWN RED GREEN BLACK AUXILIARY LED Indications : ON / Solid - Normal Operation During normal operation the Remote LED will remain solid ON as a indication of normal charging. S Slow Flashing - Auxiliary Below 12VDC OFF - No Output / Check F If the LED is completely blank it is indicative of No Output from the unit.
PAGE 4
Wiring Diagram - For Optional Start Assist- Boost upto 80A Output : For BLUE, ORANGE and GREEN Wires refer to previous wiring diagram NOTE: 100A or greater rated cabling must be used between solenoid and batteries. 100A> Rated Cable Signal Wire 100A> Rated Cable Optional Start Assist and Boost Charge: The optional Solenoid Kit (Part No. BTDC40KIT Kit Sold Separately) provide the features of the unique Start Assist and Boost Charge modes.