Product Manual

Charging your PowerTop
12V AC chargers, solar chargers and DC-DC chargers connect to the grey Anderson Plugs. All charging sources must
be under 50A. The PowerTop can be charged from 2 sources at the same time as long as the 50A total limit is not
exceeded.
The PowerTop will automatically cut out when the battery is fully charged. It also cuts out when battery gets too low.
When fully charged the battery will be at 13.3-13.5V.
Discontinue use when the battery is approximately 11V. It will automatically cut out at approximately 11V.
Voltmeter
The voltmeter with the circular ring of LED’s will give the voltage and an indication on how full the battery is. When an
appliance is connected, the voltage will dip a small amount and when a charge is applied the voltage will raise a small
amount. This is normal.
If storing for extended periods it is recommended that you switch off the battery. The lithium cells will self-discharge
very slowly if not charged for prolonged periods, so it is a good idea to charge the battery every couple of months.
Anderson Plugs
The grey Anderson plugs are bi-directional and can handle loads or charging to a maximum of 50A. This means a
maximum inverter size of 600W.
Ciga Sockets and USB sockets
Ciga sockets should only be used as intended to charge devices with a maximum load of 10A.
Contact Us
Phone: [phone]
Email: [e-mail]
www.baintech.com.au
CHARGE VIA:
• Solar (Regulated)
• 12V AC Chargers
• External DC-DC Charger