Installation Guide

Baintech 110Ah Slimline DCS Guide
Figure 4 – DCS Model Anderson Connectors
Tuning the Next Generation DC-DC Charger
As you look at the 20A DC-DC charger there is an LED and 2 rotary switches (Figure 5) on the front face
of the battery.
1. Green LED which will illuminate when the DC-DC charger is ready to charge.
2. Rotary Switch 1 on the bottom called Voltage Switch.
3. Rotary Switch 2 on the top called the Delay Switch / Ignition Trigger.
Figure 5 – DC-DC Charger Switches
The DC-DC charger is factory set at setting 4 – 0 for traditional alternators. If you want to use your DC-
DC charger in a different mode then you need to turn the two rotary switches to the correct position.
There is also an external Ignition Trigger Input, a red plug on the front face of the battery. Please
consult your auto electrician to discuss a suitable place to connect an ignition trigger input to in your
vehicle. The Ignition Trigger requires only a single 12V positive signal and uses the common ground of
the battery.