Installation Guide

Slimline Battery User Guide 2021 www.baintech.com.au
Installation & User Guide
SL Range
4
Operating outside of these guidelines diminishes the life and performance of the battery and voids
the warranty.
2.4 Avoid repeated shock and vibration
Whilst the battery is robustly constructed and protected in an aluminium enclosure, it is not
designed to operate continuously in high shock or high vibration environments. Normal use in a
4WD environment is acceptable and the battery has been designed in accordance with these
expected conditions. However, dropping the battery or exposing the battery to a high number of
excessive vibrations may lead to a fault or failure of the battery.
2.5 Avoid exposure to water or salt spray
Whilst the battery is mechanically protected, the enclosure is only IP20 equivalent and is not
designed for a wet environment. Do not submerge the battery in water or expose the battery to
direct water spray. If it is likely that a water will be on the floor where the battery is located, ensure
the battery is facing upwards with the terminals (and electronics) on the top, so that any water that
gets into the bottom can drain out again without touching the electronics.
Avoid exposing the battery long term to salty water spray such as in a marine environment to avoid
corrosion. Salt laden air may also cause corrosion in the long term; therefore, minimise exposure by
installing the battery in a protected hatch or compartment.
2.6 Do not short circuit the battery
Whilst the BMS will protect the internal cells from short circuit, it is highly recommended to avoid
short circuiting the battery.
Pay attention when using metallic tools in the vicinity of the terminals, as accidentally contacting the
positive and negative terminal with a metallic object like a spanner will cause a short circuit and
spark. Always keep the plastic caps screwed on when not using the terminals.
Always perform work on passive wiring first and connect the live battery as the last connection. If
you have to work on live circuits exercise due care and use insulated tools where possible. If you are
unsure how to install the battery, seek advice from BAINTECH or a suitably qualified electrical
tradesperson.