Installation Guide

Ph
07 3348 8082
E
[e-mail]
‘The Power Systems Experts’
www.baintech.com.au
Installing your Baintech DC Distribution Panel BTCP005
You will need
1 x Baintech DC Distribution Panel
2x Right angle spade terminals
Cable at the desired length and gauge for your appliances
How to install your panel
1. Attach the terminals to the cables
2. Connect the right angle spade terminal on the negative cable to the negative post on the rear of the ciga
socket
3. Connect the right angle spade terminal on the positive cable to the positive post on the rear of the
resettable circuit breaker
4. Mount the panel in your vehicle and connect the cables to your battery – making sure to connect the positive
cable to the positive terminal and the negative cable to the negative terminal
Wiring on the panel may vary
Specifications
Panel Size: 100 x 160 x 80mm
Operating voltage: 12V DC
USB Output: 5V DC @ 1A Maximum
4mm diameter mounting holes
All switches come off the battery positive rail