Installation Guide

Ph
07 3348 8082
E
[e-mail]
‘The Power Systems Experts’
www.baintech.com.au
Installing your 4 switch panel BTCP003
You will need
1 x Baintech 4 switch panel
5 x Right angle spade terminals
Cables at the desired length and gauge for your appliances
Appliances
How to install your panel
1. Attach the terminals to the cables
2. Connect the right angle spade terminal on the positive cable to the positive post on the rear of the
resettable circuit breaker
3. Connect the positive side of your appliances to the posts on the rear of the panel.
4. Connect the negative side of the appliances to the negative side of the battery.
5. Mount the panel in your vehicle and connect the cables to your battery – making sure to connect the positive
switch panel cable to the positive battery terminal and the negative cable to the negative battery terminal
Specifications
Panel Size: 120 x 55 x 40mm
Operating voltage: 12V DC
4mm diameter mounting holes
All switches come off the battery positive rail