Operating instructions
62
mode illuminates:
230V
12V
Gas
Changing the operating mode by pressing button
(1) again. The appropriate indicator LED will
illuminate.
MES- appliances
1. Press button (1) several times until the
indicator LED (6) illuminates.
2. The ignition process is activated
automatically by means of an automatic igniter.
The ignition system will make 2 ignition
attempts with 25 seconds interval when
the burner fails to light. If repeated
attempts fail to start the operation, a
fault is indicated (please refer to failure
indication).
Setting of the cooling compartment
temperature
Select the desired cooling compartment temperature
by pressing button (2)
The LED display (7) of the selected temperature
setting is illuminated.
The scale starts with MIN position at the bottom
LED position (small crystal = highest temperature)
and climbs up to MAX position at the upper LED
position (largest crystal = lowest temperature).
Note: The temperature levels do not relate to
absolute temperature values.
The cooling unit’s performance is inuenced
by ambient temperatures. Please select the
medium setting for ambient temperatures
between +15° and +25°. The unit operates
within its optimum performance range.
Dometic refrigerators work according to
the absorption principle. For physical
reasons, an absorption system responds slowly
to changes made by the thermostat controller, by
loss of cooling energy through opening the door or
during storing food. The devices meet the cooling
performance requirements of the Climatic Class SN
acc. To EN/ISO 7371 in the temperature range of
+10°C to 32° ambient temperature.
For temperatures below +10°C, winter covers
should be installed. For ambient temperatures
exceeding +32°C for a longer period of time, it
is recommended installing Dometic additional fan
(item no. 241 2985 00).
Additional features (MES)
The brightness of the display reduces after a few
seconds if no other buttons are pressed.
If the door is open, the interior lighting is switched
off automatically after 2 minutes.
Failures are indicated by ashing of the failure
indicator LED.
Should the door be kept open for too long (more
than 2 minutes), the blue external LED starts
ashing until the door is closed.
Frame Heating
All models are equipped with a frame heating
(12VDC/3.5W) around the freezer compartment.
During summer months with high temperatures and
humidity the metal frame may have water droplets
forming. To evaporate these droplets switch on
the frame heating with switch (3). The LED (5)
indicates that the heating is on.
The frame heating is in operation with a presetting of
2 hours and switched off afterwards automatically.
The frame heating can be deactivated every time
by pressing the button (3).
i
i