Technical information

123

Chapter 4 CARAVAN EQUIPMENT

IDM3 / IDM2000 CARAVAN ALARM (continued)

3. Press “F”. The exit delay will begin, 1 pulse per second.

4. 2 short bursts on the siren will be heard at the end of the

exit delay. This confirms the system is armed.

5. This operation can be cancelled at any time before step 4 by pressing

“C”.

Disarming the System

1. Enter your personal code. (This is the only way to disarm the system)

2. If the system has been inactive all indicators will flash twice on the

keypad.

3. If a sensor has been activated then the corresponding light on the

keypad will flash five times. However if the system had been

continuously active for 20 minutes or more (and subsequently reset)

there will be a random flashing of indicators preceding the display

of the sensor(s) responsible.

Note: When the siren is active there is no limit on key entries When the

siren is inactive a maximum of 16 key entries are allowed. If 16 key entries

are exceeded then the system will not accept any more entries until the

siren is activated.

Memory Recall

This enables the user to tell if any sensors were active during the previous

armed state.

1. Press “F”, press “5”; watch the indicators.

2. If all indicators flash twice the system has been quiet.

If any indicator flashes 5 times, the corresponding sensor has been active.

4. A random flashing of indicators followed by 5 flashes for sensor(s)

means that the system has had to reset (i.e. disarm itself) due to the

siren being active for 20 minutes.