Technical information

122
Chapter 4 CARAVAN EQUIPMENT
IDM3 / IDM2000 CARAVAN ALARM (continued)
5. This operation can be cancelled at any time before step 3 by pressing
“C”.
Changing the Siren-on Time
1. Press “F”, press “3”.
2. Enter your personal code,
3. Enter the preferred time as 3 digits, i.e. 2 minutes is entered 200, (please
note the maximum time allowed is 4 minutes, i.e. 400)
4. Press “F”.
5. This operation can be cancelled at any time before step 3 by pressing
“C”.
Setting up the Tilt Sensor
The tilt sensor is not adjustable and requires the caravan to be reasonably
level. If the Tilt Sensor is active, one of the Tilt Sensor Indicators will
illuminate on the keypad. Adjust the level of the van until the light goes
off.
Arming the System
If you are in the PIR’s line of sight, it is possible that when arming the
system, any movement detected by the PIR will deselect the PIR channel.
To avoid deselecting the PIR accidentally please ensure that you remain
perfectly still when arming the system. This is very important when the
keypad is sited within the PIR coverage area.
1. Enter the personal code, the indicators for all available sensors will
light (If a sensor indicator fails to light, see “TROUBLESHOOTING”).
2. To Disable any sensors not required, press the relevant key, i.e. 1 for
PIR, 2 for tilt, 3 for tow sensor. Repeated pressing will select (light
comes on) and disable (light goes off) the relevant sensor.