Operating instructions

88
Operation Procedure
This section includes useful information about oven
operation.
1. Connect the mains lead to an electrical outlet.
2. After placing the food in a suitable container, open
the oven door and put it on the glass tray. The glass
tray and roller guide must always be in place during
cooking.
3. Shut the door. Make sure that it is rmly closed.
4. The oven light is on only when the microwave oven
is operating.
5. The oven door can be opened at any time during
operation by pulling the handle. The oven will
automatically shut off.
6. Each time a button is touched, a BEEP will sound to
acknowledge the touch.
7. The oven automatically cooks on full power unless
set to a lower power level.
8. The display will show “:0” when the oven is plugged
in.
9. Time clock returns to the present time when the
cooking time ends.
10. When the Stop/Clear button is touched during the
oven operation, the oven stops cooking and all
information retained. To erase all information (except
the present time), touch the Stop/Clear button once
more. If the oven door is opened during the oven
operation, all information is retained.
11. If the Start button is touched and the oven does
not operate, check the area between the door and
door seal for obstructions and make sure the door is
closed securely. The oven will not start cooking until
the door is completely closed or the programme has
been reset.
Make sure the oven is properly installed and plugged
into the electrical outlet.
Wattage Output
The power-level is set by pressing the power
button.
If you touch the power button once, the power level will
be at 100%, if you press it twice the power will reduce by
20% and each subsequent time it is pressed the power
will reduce by 20%. If it is pressed 6 times the power
will go back up to full again.
Controls
Setting the Clock
When the oven is rst plugged in, the display will ash
“:0” and a tone will sound. If the AC power ever turns off,
the display shows “:0” when the power comes back on.
1. Press the Clock button. This is a 12 hour clock
system.
2. Press the Clock button once more. This is a 24 hour
clock system.
3. Turn the dial knob to adjust hour.
4. Press the Clock button.
5. Turn the dial knob to adjust minute.
6. Press Clock Button
This Oven has multiple clock systems. If you
want the 12 hour clock system omit this step.
If you selected 12 hour system, the display will
show the hours from “1” to “12”.
If you selected 24 hours system, the display will show
the hours from “0” to “23”.
The adjusted hours starts blinking.
The minute stops blinking and “00” starts blinking.
The display will show the minutes from “0” to “59”.
The adjusted minute starts blinking.
When you press the Clock button, the minute
stops blinking, and the colon starts blinking.
If you selected 12 hours clock system, this
digital clocks allows you to set from 1:00 to
12:59. If you selected 24 hours clock system,
this digital clock allows you to set from 0:00
to 23:59.
Weight Defrosting
“Weight Defrost” lets you easily defrost food by
eliminating guesswork in determining defrosting time.
The minimum weight for “Weight Defrosting is 200
grams and the maximum is 3,000 grams. Follow the
steps below for easy defrosting.
1. Press Defrost button (The DEF indicator and “0”
appear the g indicator starts blinking).
2. Turn the dial knob to adjust the defrosting weight
(The display will show what you selected).
3. Press Start button.
When you press Start button, the g indicator disappears
and the DEF indicator starts blinking to show the oven
is in the DEFROST mode. The display counts down the
time to show you how much defrosting time is left in the
DEFROST mode. The oven beeps during the defrosting
cycle to signal that the food needs to be turned or
rearranged. When the defrosting time ends, you will hear
3 beeps.
Time Defrosting
When TIME DEFROST is selected, the automatic cycle
divides the defrosting time into periods of alternating
defrost and stand times by cycling on and off.
1. Press Defrost button (The DEF indicator and “0”
appear and the g indicator starts blinking).
2. Press Defrost button once more (The g indicator
disappears and “0” is displayed).
3. Turn the dial knob to adjust the defrosting time (The
display will show what you have selected).
4. Press Start button.
Your oven can be programmed for 60 minutes 00
seconds (60:00).
When you press Start button, the DEF indicator
starts blinking to show the oven is in DEFROST
mode. The display counts down the time to show you
how much defrosting time is left in the DEFROST mode.
The oven beeps during the defrosting cycle to signal
that the food needs to be turned or rearranged. When
i
i
i