Operating instructions

72
The control knob/push button (8) is used to select menus
in the lines (3+4) and congure the settings. These
are shown via a display (1) with a lighted background.
Pressing the Back button (9) takes the user back out of
the menu again.
Control knob/push button
The control knob/push button (8) is used to select and
change set values and parameters: these can be saved
by clicking the control knob/push button. Selected menu
items will ash.
Turn to the right (+)
• Menu is paged from left to right.
• Increase values.
Turn to the left (-)
• Menu is paged from right to left.
• Reduce values.
Clicking
• Accept (save) a selected value.
• Select a menu item, change to
the setting level.
Press (3 seconds)
• Main switch function ON/OFF
Back Button
Pressing the Back button (9) takes the user back out of
the menu again and discards the settings. This means
that the previous values are retained.
Functions
The functions in the menu lines (3,4) of the control
panel can be selected in any sequence. The operating
parameters are shown in the status line (2) or the
displays (5, 6).
Start/standby screen
After connecting the control panel to the power supply,
a start screen is shown after a few seconds.
If no entry is made within a few minutes, the standby
screen is automatically shown again. The display shows
the time and correct room temperature alternately.
Switch on/return to setting level
• Press the control knob/push button for longer than 3
seconds or the
• Back button.
The display shows the setting level. The rst symbol
ashes.
!
Previously set values/operating parameters
become active again after the system is
switched on.
Switch off
• Press the control knob/push button for longer than 3
seconds.
Change the room temperature
• Use the control knob/push button to select the symbol
in menu line (3).
• Click to change to the setting level.
• Depending on the connected device, use the control
knob/push button to select between the heater or air
conditioning unit.
• Use the control knob/push button to select the
required temperature.
• Click the control knob/push button to conrm the
value.
Heater
Settable temperature range 5 – 30oC (1oC steps)
a = heater * - Heater is switched on.
* This symbol will ash until the required room
temperature is reached.
Change the warm water level
• Use the control knob/push button to select the symbol
in menu line (3)
• Click to change to the setting level.
• Use the control knob/push button to select the
required level.
• Click the control knob/push button to conrm the
value.