Operating instructions

Electrical Operating Instructions (230v)

Ensure that the water heater is full then switch the isolation

switch on. (Usually mounted on the bunk face adjacent to the

gas control switch.)

The water temperature cannot be selected;

temperature is automatically limited to 70°C.

For a faster heating up the appliance can be

simultaneously operated with gas and electrical

power.

General Safety Notes

In the event of leaks in the gas systems or if

there is a smell of gas:

Extinguish all naked ames.

Do not smoke.

Switch off appliance and gas cylinder.

Open the windows

Do not operate any electrical switches

Have the entire system checked by an expert.

Repair Jobs are only to be carried out by an expert.

The Following would invalidate the guarantee:

• Any alteration to the appliance (including cowl.)

• The use of non-Alde spare parts/accessories

• Non observance of the operating instructions

The operating pressure for the gas supply is 30mbar

(or for 28mbar butane/ 37 mbar propane) and must

correspond to the operating pressure of the appliance

(see name plate.)

Do not operate the water heater when refuelling the

vehicle and when in the fuel station.

During initial operation of a brand new appliance (or

after it has not been used for some time), a certain

amount of fumes and a slight smell may be noticed for a

short time. Remedial action here is to immediately run

the heater at maximum output and to ensure adequate

room ventilation.

If the burner makes an unusual noise or if the ame

lifts off, it is likely that the regulator is faulty and it is

essential to have it checked.