Operating instructions
48
Tap the arrow keys to move the cursor along each of the
3 programmable times, using the + and - keys to select
the on and off time, the desired temperature and the
desired heat setting. The thermostat setting can range
from a minimum of 18˚C up to a maximum of 35˚C.
Available heat settings are:
• Gas only
• Fan only
• 1000W plus Gas (boost setting)
• 500W
• 1000W
• 2000W
• Off
Please note: The timer function must be adjusted so that
the start time is before the nish time.
Return to the home screen. The room icon and timer icon
will be red to show that the timer function is activated.
Turning the timer OFF:
To turn the timer function off, tap the red timer icon on
the home screen, the icon will return to blue, to indicate
that the timer function has been turned off:
For Water Heating:
To set the water timer touch the spanner icon on the
home screen and then press Water Timer.
Use the plus and minus keys to adjust the heat, time and
temperature settings. Use the left and right arrows to
move the cursor along to the next setting/ line.
The Water Heater may be programmed 3 times during a
24 hour period.
Tap the arrow keys to move the cursor along each of the
3 programmable times, using the + and - keys to select
the on and off time and the desired heat setting.
Available heat settings are:
• 750W
• 1500W
• 750W plus Gas
• 1500W plus Gas
• Gas only
• Off
Please note: The timer function must be adjusted so that
the start time is before the nish time.
Return to the home screen. The water icon and timer icon
will be red to show that the timer function is activated.
Turning the timer
OFF:
To turn the timer function off, tap the red
timer icon on the
home screen,
the icon
will return to blue, to indicate that the
timer function has been turned
off:
Quick Timer Settings:
I Van will remember the last programmed settings. To
quickly activate the previously set timer settings for
both
Space
and Water Heating, tap the timer icon on
the home screen, the icon will turn red to show that the
timer function
(with
the last programmed settings) has
been
activated:
Operating the Pump
The water pump works on a pressurised system – it will
pump up the system until working pressure is reached,
and
then will switch itself off. When the pressure drops
when a tap is opened, the pump will start to run and will
continue
to run until the pressure builds up again after
the tap is
closed.
On the I Van control panel you can see if the pump is
running by checking the pump
icon.
Blue icon with a grey bar indicates that the pump has
been isolated
Red icon with a grey bar indicates that the pump is
turned on but is not running
Red icon with a red bar indicates that the pump is turned
on and running.