Operating instructions

47
* Heat Boost Setting: This uses gas and electric
simultaneously for higher heat outputs. It intelligently
balances between gas and electric settings, varying the
heat output accordingly to maintain the selected room
temperature.
** Frost Protection Setting: This uses a small amount
of power to maintain a very low temperature in the van,
reducing the chance of frost damage occurring. See
page 43 for winterising guide.
4. Select the desired room temperature (ranges
from 18˚C to 35˚C) using the - and + buttons.
5. Once the desired heat setting has been activated,
press the home button to return to the home screen:
The home screen will now show the ‘Van’ icon in red with
the selected heat setting displayed.
Operating the Water Heater
1. From the home screen, touch the ‘Tap’ icon:
2. The following screen will appear:
Fig 4: Water Heater Screen Display
3. Select the desired heat setting by tapping one of
the following icons. The icon will turn red to show it has
been activated.
Icons Available Heat
Settings
Description.
750W (3.25A) Electric Low
Setting
Low Power
Setting*
1500W (6.5A) Electric on High
Setting
Heat Boost
Settings**
Gas Gas
Gas & 750W Gas & electric
Low setting
Gas & 1500W Gas & electric
high setting
Off Turns Heater Off
* Low Power Setting: This uses only 750W (3.25A).
Unlike the heat boost settings, the low power setting
does not operate on a timer, therefore the timer function
will remain at 0. When this setting is enabled, the water
heater will remain CONSTANTLY ON, until all water
heater settings are turned off. The “low power” setting
is best used when the vehicle is connected to a mains
supply with limited current capacity.
Running several appliances at once will increase the
current drawn by the van, which depending on the rating
of the circuit breaker, could trip the supply. So if several
appliances are running at the same time, the “low power”
setting can be used to keep the water heating but with a
reduced current draw.
** Heat Boost Setting: As outlined on the table above,
there are a number of combinations that can be selected
under ‘Heat Boost Settings’ depending on the desired
power/gas usage and the required heat-up time. When
using any combination of these settings, the timer will
count down from 15 mins default. If a larger amount of
hot water is required over a longer time period e.g. if 3
or more showers are required in quick succession, the
timer function can be changed to 30, 45, 60 mins or to
be always on.
To change the default timer function, from the home
screen, tap the spanner icon and use the arrow keys to
scroll through to the ‘Water Heater Boost time’ screen.
Select the desired timer setting using the plus and minus
keys. Note: if ‘always on’ is selected, the
Water Heater will remain CONSTANTLY ON, until all
Water Heater settings are turned off.
4. Once the desired heat setting has been activated,
press the home button to return to the home screen:
The home screen will now show the ‘Tap’ icon in red with
the selected heat setting displayed.
Programming the Timer
For Space Heating:
To Set the Room Timer, touch the spanner icon on the
home screen, then press Room Timer.
Fig 5: Space Heater Timer screen.
The Space Heater may be programmed 3 times during a
24 hour period.