Operating instructions

94
The LED (6) of the previously selected operating mode
illuminates:
Changing the operating mode by pressing button (1)
again. The appropriate indicator LED will illuminate.
MES- appliances
1. Press button (1) several times until the indicator
L E D (6) illuminates.
2. The ignition process is activated automatically by
means of an automatic igniter.
The ignition system will make 2 ignition
attempts with 25 seconds interval when the
burner fails to light. If repeated attempts
fail to start the operation, a fault is indicated
(please refer to failure indication).
Setting of the cooling compartment temperature
Select the desired cooling compartment temperature by
pressing button (2)
The LED display (7) of the selected temperature setting
is illuminated.
The scale starts with MIN position at the bottom LED
position (small crystal = highest temperature) and climbs
up to MAX position at the upper LED position (largest
crystal = lowest temperature). Note: The temperature
levels do not relate to absolute temperature values.
The cooling unit’s performance is inuenced
by ambient temperatures. Please select the
medium setting for ambient temperatures
between +15° and +25°. The unit operates
within its optimum performance range.
Dometic refrigerators work according to the
absorption principle. For physical reasons, an
absorption system responds slowly to changes
made by the thermostat controller, by loss
of cooling energy through opening the door or during
storing food. The devices meet the cooling performance
requirements of the Climatic Class SN acc. To EN/ISO
7371 in the temperature range of +10°C to 32° ambient
temperature.
For temperatures below +10°C, winter covers should be
installed. For ambient temperatures exceeding +32°C
for a longer period of time, it is recommended installing
Dometic additional fan (item no. 241 2985 00).
Additional features (MES)
The brightness of the display reduces after a few seconds
if no other buttons are pressed.
If the door is open, the interior lighting is switched off
automatically after 2 minutes.
Failures are indicated by ashing of the failure indicator
LED.
Should the door be kept open for too long (more than 2
minutes), the blue external LED starts ashing until the
door is closed.
Frame Heating
All models are equipped with a frame heating
(12VDC/3.5W) around the freezer compartment. During
summer months with high temperatures and humidity
the metal frame may have water droplets forming. To
evaporate these droplets switch on the frame heating
with switch (3). The LED (5) indicates that the heating
is on.
The frame heating is in operation with a presetting of 2
hours and switched off afterwards automatically. The
frame heating can be deactivated every time by pressing
the button (3).
Door Locking
Manual door lock
Open the door by pressing the locking button and pull
open.
230V Operation
12V Operation
Gas Operation
i
i