Technical information

117
Chapter 4 CARAVAN EQUIPMENT
M. E. C. CARAVAN ALARM PAS 2
Operating the alarm
The PAS 2 is simple to arm and disarm using the same procedures for
both operations.
The functions of the alarm can be operated by entering the correct code
into the keypad, which should be done, in the following sequence.
Activate the keypad, enter your code, and enter the code for the required
operation.
Note: The alarm code is initially set in the factory to 1111 (four 1’s).
To ARM the alarm, follow this sequence.
Press * To activate the control panel, the red LED should
be illuminated to indicate the keypad is
activated.
Press 1111 To enter your alarm code.
Press 1 To arm the system, red and green LED will be
illuminated for 2 seconds.
If wrong code is entered, red and green LED’s will flash for 10
seconds.