Installation Guide

4
Safety Information
Caution: Before handling the SmartUPS, read the following information concerning
stored battery power.
For air and sea transportation safety, during shipment the Baicells SmartUPS product can only be
charged about 20% to 30%. Because of the self-discharge of the lithium battery, if the SmartUPS
device is not installed within 3 months after reaching its destination, it must be recharged to 80%.
After recharging, the SmartUPS device may be stored for up to 6 months. If the device must be
stored longer than 6 months, repeat the recharging to 80%.
For the safety of installation personnel and for the protection of the equipment from damage, please
read all safety warnings. If you have any questions concerning the warnings, before installing or
powering on the eNB, contact the Baicells support team.
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents.
Warning Read the installation instructions before you connect the system to its power source.
Warning Installation of the equipment must comply with local and national electrical codes.
Warning This product relies on the existing building or structure for short-circuit (overcurrent)
protection. Ensure that the protective device is rated no greater than 20A.
Warning Do not operate this wireless network device near unshielded blasting caps or in an
explosive environment unless the device has been modified and qualified for such use.