Installation Guide

31
Figure 5-11 Create WAN1 Interface with VLAN ID Settings
4. Set up the WAN1 interface configuration, shown in Figure 5-12 WAN1 configuration Settings.
Setup the IP address, mask, gateway, broadcast address, then click the ‘SAVE&APPLY’
button
Figure 5-12 WAN1 configuration Settings
5. To make sure all those settings are done correctly, next step is to check the UPS configuration
file
6. Start putty or other ssh client tools program. Here we take putty as ssh client, set the
configuration as Figure 5-13 ssh client configuration