Installation Guide

29
5.5 Configure VLAN
When the UPS needs VLAN ID to connect to OMC, it should be configured the WAN interface
with VLAN ID.
Two steps should be followed:
1. Set VLAN ID, it can be done either by modifying existing VLAN ID, or by adding one new
VLAN ID(other than VLAN ID 1, VLAN ID 2)
2. Set the IP protocol, IP address of the WAN1 interface(new VLAN ID bundled)
Please make sure the UPS software version is above
BaiCE_UPS_1.0.4_MY-APP. It can be checked
by one web browser.
Figure 5-8 UPS software version
The default VLAN TAG is 1005, in case 1005 is not the chosen VLAN ID, please go through the
following steps.
1. Go to the Switch setup page, modify the VLAN ID, then click ‘SAVE & APPLY’ button, shown in
Figure 5-9 modify VID