Installation Guide

24
Figure 4-12: Battery Switch
Refer to
Table 1-2 LEDs to check that the power LED is indicating the SmartUPS is powered on. As the
SmartUPS begins accumulating current, you will be able to see the battery LEDs progressively light up:
30%, 70%, and then 100%. At 100%, the SmartUPS is fully charged.
4.8 Close the Wiring Cavity Cover
After all of the cables have been connected to the SmartUPS, the battery switch has been turned ON,
and the LEDs are lighting as expected, close the cover on the wiring cavity and use an M4 cross
screwdriver to tighten the screws.