Installation Guide

18
4. Installation Procedures
4.1 Process Overview
Figure 4-1 provides an overview of the SmartUPS installation process. Follow each section to
complete the installation.
Figure 4-1: Installation Process
4.2 Mount Unit on Pole or Wall
Refer to section 4.2.1 if you are installing the SmartUPS on a pole. Refer to section 4.2.2 if you are
installing the SmartUPS on a wall.
4.2.1 Pole Installation
The diameter of the pole must be between 1.6–3.9 inches (40–100 millimeters). The recommended
height of the installed SmartUPS is greater than 47 inches (120 centimeters).
Follow the steps below for a pole installation.
NOTE: The unit comes with the mounting bracket already assembled.
1. Unscrew the 4 screws on the assembled bracket and slide the 2 outer omega clamps to the
end of the threeadd road, as shown in Figure 4-2. Then, turn the upper omega clamp up and
the lower omega clamp down so they are out of the way when you place the bracket on the