Specifications

FCC Radiation Exposure Statement

The modular can be installed or integrated in mobile or fix devices only. This modular cannot be installed in

any portable device, for example, USB dongle like transmitters is forbidden.

This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The

maximum allowable antenna gain is 10dBi. This modular must be installed and operated with a minimum

distance of 20 cm between the radiator and user body. The allowed antenna type is external antenna.

If the FCC identification number is not visible when the module is installed inside another device, then the

outside of the device into which the module is installed must also display a label referring to the enclosed

module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID:

2AG32EM2148M .

When the module is installed inside another device, the user manual of this device must contain below

warning statements;

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause

undesired operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

The devices must be installed and used in strict accordance with the manufacturer's instructions as

described in the user documentation that comes with the product.

3. List of applicable FCC rules

This module has been tested and found to comply with part 25 requirements for Modular Approval.

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules)

listed on the grant, and that the host product manufacturer is responsible for compliance to any other

FCC rules that apply to the host not covered by the modular transmitter grant of certification. If the

grantee markets their product as being Part 15 Subpart B compliant (when it also contains

unintentional-radiator digital circuity), then the grantee shall provide a notice stating that the final host

product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.